iSpeech Synthesizer is the voice synthesizer to read texts to your iDevice.
iSpeech Synthesizer is a simple program, you can type or paste text into the interface and press Speech to listen to your device that reads what has been written with language, speed, tone and volume set to your liking. The controls at the bottom of the interface you can adjust the speed, change the pitch, volume, and set the language, while at the top then type or paste the text to be read or to sing to your device.
Adding T and a value (example 1.0) you can adjust the tone to be used until the next change of the parameter.
Adding V and a value (example 0.5) you can adjust the volume to be used until the next change of the parameter.
Adding S and a value (example 1.0) you can adjust the speed to be used until the next change of the parameter.
Adding L and a value (example: 1) you can set the language to be used until the next change of the parameter.
Note: The values are not whole, (example: 0.5) must be compiled with the "." and not with "," otherwise the value will not be accepted
As regards the L value is an integer so just enter the number that you want (example: 9 for English)
- Shake the device to clear all text.
Example:
T0.1 L9 S0.3 Hello (the application will read in English " L9" with the lowest tones available " T0.1" at a slow speed " S0.3")
If you do not enter any of the parameters T+Value, V+Value, S+Value L+Value, the system shall be to those set on the slider.